1)    Never build a room to fit your mats!  The mats are made of foam.  Therefore, they will vary slightly in length and width.  If you build a room to fit the mats, chances are you will not get a perfect fit!

2)    If you would like to frame in your mats you can use our Mat Framing Kit. 

3)    If you would like to make your own frame, a lot of people find the 1 x 4 lumber works really well.  If you like you can bevel one edge to minimize tripping.  However, you can use what ever trim fits your schools needs.

4)   Always finish staining or painting you trim before you install it.  Pre-drill holes in your trim a maximum of 18" apart.  Put the holes closer together if you are using a soft wood.

5)    Lay the lumber snuggly next to the mats and anchor it to the floor.  Use wood screw if you are going into a wood floor or tapcon screws if you are going into concrete.  You will need to pre-drill the hole in the concrete before you put the screw in.  You will need to rent a hammer drill if you don’t have one when drilling into concrete.

6)    Use a miter box or chop saw to bevel the trim to go around corners.  This will give your trim a more finished look.

7)    Make sure the trim height is slightly lower than the mat height.  This will minimize any injuries do to falls by the edge of the mat.

8)    Enjoy the nicely finished edge of your mats!